Cabur Solar “Line 4” connectors allow simple and effective connections.
The Line 4 connectors are composed by:

• Flying connectors, male and female
• Panel connectors, male and female
• Y connectors

All Cabur Solar “Line 4” connectors are supplied with caps and relative accessories.
In order to assure a connection compliance with standard, Cabur reccomend use of pliers IS3161N.
The use of this tools is mandatory for guaranteed a excelent connection and the duration of the plant.

FAST, SIMPLE, AND EFFECTIVE: CONNECTION IN JUST THREE STEPS

1. Insert the stripped wire into the contact to be
   crimped -CRIMP IT-.
2. Insert the wire complete with contact into the connector and push hard until you hear the typical CLICK which indicates that the plastic and metal parts are hooked together. Do not make any joints without checking that the plastic and metal parts are hooked together.
3. Screw on the wire gland washer manually until it is firmly homed to guarantee IP67.

LINE 4 FLYING MALE – FEMALE CONNECTORS

The fly connectors, both male and female, are made by four main parts:

1. Metallic PIN
2. Rubber washer
3. Rigid PPO plastic washer
4. Main body made of PPO plastic

1. Pin is a metallic contact made of tinned copper composed by two metallic wings allowing cable tightening via crimping action. The pin wings should be bending around the cable core. This action should be done with the appropriate Cabur Solar accessories.

   

2. Rubber washer is used to protect internal part of the connector, thus preventing penetration of external agents such as humidity, dust, and oils. This is achieved by pinching the electric wire insulating sleeve.

   

3. PPO plastic washer has a conical cavity that, after being screwed into the main body of the connector, forces the reeds together, compressing the rubber sheath into the wire insulation and hence acting to help ensure IP67 protection.

   

4. The main body holds the metallic PIN crimped onto
   the cable.

   

Connection from male and female connectors is made having the male metallic PIN paired with the female PIN, vice versa happens for the plastic shells.
Female connector has one red rubber ring which acts as insulating washer against the penetration of external atmospheric agents.
Male and female connectors are hooked together mechanically by means of two elastic wings on the female connector which must be inserted in the male connectors insulating body special slots.

MALE-FEMALE PANEL CONNECTORS OF LINE 4

The connector are made by three parts:

1. Metallic PIN
2. Rigid PPO hexagonal plastic washer
3. Main body made of PPO plastic

1. Metallic PIN is similar to the one of the flying version
2. Hexagonal nut allows locking the connector on panel surface. Pay attention to the strength used to block the connector as, if excessive, could damage the connector.
3. Main body made of PPO plastic is similar to the one of the flying version.